Error code

Mitsubishi Electric PUZ code 6608

For your safety

This fault is rated high and involves an area that affects personal safety. No remote repair or do-it-yourself instructions are given; do not use the appliance or try to open or repair it.

Hazard area: mains voltage

Do not use the appliance and call an authorised service. If there is a risk to life, move to a safe place and see the emergency numbers.

The emergency numbers here are for Turkey. If you are outside Turkey, call your local emergency number.

All emergency numbers and province details

No approved translation for this record yet; showing the original text.

Meaning

10-5. TROUBLESHOOTING 1. Remote controller work. 2. “PLEASE on the remote 3. When pressing operation display is turned off: M-NET NO RESPONSE Abnormal if a message was there were reply (ACK) that received, but response command return. Transmitting side detects every 30 seconds, 6 times Note: The address and attribute remote controller indicate ler that did not reply Phenomena display does not WAIT” display is remained controller. the remote controller switch, the OPERATION appeared but it will be soon. the wireless 1 The no beep is heard controller not start operating. is indicated on the wireless 1 No operation beep

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

(1) Transmitting condition is repeated 1 transmitted and fault because of noise and the message was like. 2 does not 2 Extinction of transmission wire abnormality voltage and signal is caused by continuously. over-range transmission wire. ...... displayed at • Maximum distance 200 m the control- • Remote controller line矣(12 m) (ACK). 3 Extinction of transmission wire voltage and signal is caused by type-unmatched transmission wire. Type......... With shield wireCVVS, CPEVS With normal wire (no shield)- VCTF, VCTFK, CVV CVS, VVR, VVF, VCT ..... mm2 Diameter 1.25 or more (4) Accidental malfunction of abnormality-generated controller OF PROBLEMS Factor (1) 12 V DC is not supplied to remote controller. (Power supply display is not indicated on LCD.) (2) 12–15 V DC is supplied to remote controller, however, no display is indicated. • “PLEASE WAIT” is not displayed. • “PLEASE WAIT” is displayed. (1) At longest 2 minutes after the power supply “PLEASE WAIT” is displayed to start up. (2) Communication error between the remote controller and indoor unit (3) Communication error between the indoor and outdoor unit (4) Outdoor unit protection device connector is open. (1) After cancelling to select function from the remote controller, the remote controller operation switch will be not accepted for approx. 30 seconds. Factor pair number settings of the wireless remote 1 Check and indoor controller board are mismatched. for 2 minutes at most after the power 1 Normal ON. remote controller o

Solution

Solution steps are not shared for faults that may be dangerous.

No do-it-yourself solution is given for this fault. For your safety, call an authorised service.