Error code

Mitsubishi Electric PU code A2

No approved translation for this record yet; showing the original text.

Meaning

Hard ware error of transmission Pline Transmission processor intended to transmit “0”, but “1” appeared on transmission wire. Note) The address and attribute display at remote controller indicate the controller that detected abnormality.

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

(1) Error is detected if waveform is transformed when wiring works of transmission wire of outdoor unit, indoor unit, FRESH MASTER or LOSSNAY are done, or polarity is changed with the power on and transmission data collide each other. (2) Defective transmitting receiving circuit of transmission processor (3) Transmission data is changed by the noise on transmission.

Solution

Solution steps are available to members and are not shown on this page. Answer the questions to open the solution.

Remote technician support

Get help from a technician over a video call.

Send a message Voice call Video call