Error code

Mitsubishi Electric PLA code E2

For your safety

This fault is rated high and involves an area that affects personal safety. No remote repair or do-it-yourself instructions are given; do not use the appliance or try to open or repair it.

Hazard area: mains voltage and refrigerant gas circuit

Do not use the appliance and call an authorised service. If there is a risk to life, move to a safe place and see the emergency numbers.

The emergency numbers here are for Turkey. If you are outside Turkey, call your local emergency number.

All emergency numbers and province details

No approved translation for this record yet; showing the original text.

Meaning

controller cannot be operated normally. (Error code: E2) BY INFERIOR PHENOMENA Cause board • When LED1 on indoor controller Power supply of rated voltage door unit. Defective outdoor controller Power supply of 208/230V unit. Defective indoor controller (For the separate indoor/outdoor ply system) Power supply of 208/230V indoor unit. The connectors of the optional not used. Defective indoor controller • When LED1 on indoor controller Mis-setting of refrigerant address (There is no unit correspon

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

Note: Refer to the manual of outdoor controller. board is also off. Cause controller board is also blinking. of indoor/outdoor unit connecting controller wires unit system, 2 indoor units are for outdoor unit is wrong or not system, there are some units address is 0. or connection failure of connector vane does not work. to fixed position. wireless remote controller connector (CNB) on wireless connector (CN90) on indoor confailure) between wireless remote indoor controller board

Solution

Solution steps are not shared for faults that may be dangerous.

No do-it-yourself solution is given for this fault. For your safety, call an authorised service.