Skip to content
RemFixitSearch fault code

Error code

Mitsubishi Electric PCA code E2

For your safety

This fault is rated high and involves an area that affects personal safety. No remote repair or do-it-yourself instructions are given; do not use the appliance or try to open or repair it.

Hazard area: mains voltage and refrigerant gas circuit

Do not use the appliance and call an authorised service. If there is a risk to life, move to a safe place and see the emergency numbers.

The emergency numbers here are for Turkey. If you are outside Turkey, call your local emergency number.

All emergency numbers and province details

No approved translation for this record yet; showing the original text.

Meaning

Abnormal if the clock function of remote 2 controller cannot be normally operated. (Error code: E2) BY INFERIOR PHENOMENA Cause board • When LED1 on indoor controller Power supply of rated voltage 1 door unit. Defective outdoor controller 2 Power supply of 220~240V 3 unit. Defective indoor power 4 Defective indoor controller 5 (For the separate indoor/outdoor ply system) Power supply of 220~240V 1 indoor unit. The connectors of the optional 2 not used. Defective indoor controller 3 Defective ind

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

Note: Refer to the manual of controller. board is also off. is not supplied to outCheck 1 supply • When Check and • When —Check circuit board. board. controller unit power supAC is not supplied to Check 1 terminal • When Check • When -Check replacement kit are Check 2 method • When of Connect ring kit. • When method -Check board. Cause indoor controller board is also blinking. of indoor/outdoor unit connecting controller wires indoor unit system, 2 or more indoor together. for outdoor unit is wrong or not control system, there are some units address is 0. controller wires controller OR INDOOR UNIT MICRO emergency operation starts as as follows; machine operation of the switch (SWE) on the detected during self-diagnosis. (Error the power supply ON/OFF. operated by the remote controller. when the outdoor unit starts Other wire, heat exchanger the switch setting, etc. in former position the vane slowly by Check points the resistance using a tester. (Refer to <Thermistor shor

Solution

Solution steps are not shared for faults that may be dangerous.

No do-it-yourself solution is given for this fault. For your safety, call an authorised service.