Mitel All models error codes
Codes
- a3300Error codeLS/GS Trunks
- A5215Error codePhone fails to boot up. Set display shows “Port Access Failure - Rebooting”
- DS1Error codeAll calls on a DS1 or CEPT card link fail
- E1Error codeNSU fails to boot, with an error message. Boot line timeout
- E2TError codeE2T card defective
- E911Error codeEmergency call does not trigger E911 local notification
- han30Error codeNSU or PRI card fail to load after upgrade or database restore
- han64Error codeExcessive noise on the LAN
- icp44Error codeICP 44 is healthy and is currently streaming calls in survival state
- in0Error codeYou see the following log while you are monitoring the RTC shell on boot up: Starting up VM Corp Dir... ...Fault detected while starting up VM Corp Dir. Starting up SMTP Client Starting up SMTP Server tAppStartup ProcessorCoordinator started component ADAPTATION LAYER COORDINATOR _ _ tAppStartup ProcessorCoordinator started component APPLICATION LAYER COORDINATOR _ _ ResourceAlarmStartup ready. Task StartupHwRst being deleted while ACTIVE Voice Mail Starting in 0 minutes. Starting iPVM Version 6.21.00 Voice Mail Successfully Started
- ith100Error codeCXi II alarms show FAN alarm with 100% failure
- L0Error codeAlarm indication from far end
- L1Error codeNSU fails to load after upgrade or install with “Unexpected database error”
- L2Error codeMAC address of the STP Layer 2 switch where the IP device was connected on first registration or registration after a move. - “Unknown” device is one that does not support STP with its current firmware load. A ‘Reload’ of set firmware may be required. - “Not Supported” device indicates that L2 switches do not support STP. Contact the L2 switch provider; an upgrade may be required
- ows98Error codeMissing required DLL file
- R2Error codeUnable to establish a connection between the IMAT PC and the PRI or R2 card
- SP2Error codeInternet Explorer settings
- SX-2000Error codeFault in peripheral switch control
- T1Error codePostSoftware Log: StartUp (BindId=0) pCOam->coDspBoot failed with: DSP PROGRAM ERROR _ _ for card: 3 and dsp: 0