Makita akülü testere All models error codes
Codes
- en4Error codeOperations Switching ON/OFF Clear Message Codes Press ON but- 1x 2x If the info icon appears with a i ton 2 sec to start number, observe the instruc- continuous laser tions in section "Message mode. If no key Codes". is pressed for Example: 2 sec 180 sec, the de- Leave actual vice switches off Device is Undo last action. function, go to de- automatically. turned OFF. fault operation mode
- en14Error codeMessage Codes Care Safety Instructions If the message Error does not disappear • Clean the device with a damp, soft cloth. The person responsible for the instrument after switching on the device repeatedly, • Never immerse the device in water. must ensure that all users understand contact the dealer. • Never use aggressive cleaning agents these directions and adhere to them. If the message InFo appears with a or solvents. Areas of responsibility number, press the Clear button and observe the following instructions: Responsibilities of the manufacturer of the original equipment: No. Cause Correction Makita Corporation Anjo, 156 Transverse tilt Hold the instrument Aichi 446-8502 Japan / greater than 10° without any transverse tilt. Makita, Jan-Baptist Vinkstraat 2, 3070, 162 Calibration mistake Make sure, the device Belgium is placed on a abso- Internet: www.makita.com lutely horizontal and flat The company above is responsible for surface. Repeat the supplying the product, including the User calibration procedure. If the mistake still occurs, Manual in a completely safe condition. contact your dealer. The company above is not responsible for 204 Calculation error Perform measurement
- en16Error codeSafety Instructions FCC statement (applicable in U.S.) Laser classification Labelling This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal- lation.This equipment generates, uses and The device produces visible laser beams, can radiate radio frequency energy and, if which are emitted from the instrument: not installed and used in accordance with It is a Class 2 laser product in accordance the instructions, may cause harmful inter- with: ® ference to radio communications. • IEC60825-1 : 2014 „Radiation safety of Makita xxxxL xxD x x0 xx8 x0 xxP x xxxxxxx However, there is no guarantee that inter- laser products“ ference will not occur in a particular instal- Made in Hungary Batteries: 2 x AAA Laser Class 2 products: lation. If this equipment does cause harmful interference to radio or television Do not stare into the laser beam or direct it C1La0o s4m e0rp. 1Nli1e o set ixw cceiet Npht o2 f.1 o5Cr0 Fd, R de av1it0ae4tdi0o J.n1 u0sn peau n 2rd 4s ,u 2a0n0t 7to reception, which can be determined