Kemp load balancer All models error codes
Codes
- 001-051Error codeBK ERROR SIDE CAL USER _ _ _ _
- 001-052Error codeBK ERROR NO CAL USER _ _ _ _
- 001-053Error codeBK ERROR FAIL CAL USER _ _ _ _
- 001-054Error codeBK ERROR VIRT DIM OUTOFRANGE _ _ _ _
- 001-055Error codeBK ERROR C1 100G LOW _ _ _ _
- 001-056Error codeBK ERROR C2 100G LOW _ _ _ _
- 001-057Error codeBK ERROR C1 0G HIGH _ _ _ _
- 001-058Error codeBK ERROR C2 0G HIGH _ _ _ _
- 001-059Error codeBK ERROR C1 USERCALTOOL LOW _ _ _ _
- 001-060Error codeBK ERROR C2 USERCALTOOL LOW _ _ _ _
- 001-070Error codeBK ERROR SPOKE SAME POS _ _ _ _
- 001-071Error codeBK ERROR UG NOT BET SPOKES _ _ _ _ _
- 001-072Error codeBK ERROR ANG SPOKES TOOHIGH _ _ _ _
- 001-073Error codeBK ERROR ANG SPOKES FAIL _ _ _ _
- 001-080Error codeBK ERROR SPINUP TIMEOUT _ _ _
- 001-081Error codeBK ERROR NO ACCELERATION _ _ _
- 001-082Error codeBK ERROR SPEED LOW _ _ _
- 001-083Error codeBK ERROR SPEED HIGH _ _ _
- 001-084Error codeBK ERROR REVERSE TURN _ _ _
- 001-085Error codeBK ERROR SLIP DETECTED _ _ _
- 001-090Error codeBK ERROR STUCK CLAMP _ _ _
- 001-091Error codeBK ERROR STUCK UNCLAMP _ _ _
- 001-092Error codeBK ERROR CLAMP MAXDISP _ _ _
- 001-093Error codeBK ERROR CLAMP TIMEOUT _ _ _
- 001-094Error codeBK ERROR CLAMP LOCKED _ _ _
- 001-095Error codeBK ERROR CLAMP SLIP _ _ _
- 001-096Error codeBK ERROR CLAMP FALLBACK _ _ _
- 001-100Error codeBK ERROR WATCHDOG _ _
- A7Error codePower on time counter (-> time stamp for error recording)
- F11Error codeError in expression Mod C3, User Interface : Communication Error between balancing kernel and user interface (BK -> UI). This error can be cleared by pressing STOP or Escape. This error can caused by a bad connection of the RS2 32-E serial line. Check external and internal cabling
- F17Error codeNot running (still not initialised) This error can occur after a measuring run, if the incre mental encoder of the power clamp is not able to de tect the reference mark (810F17). Please check the incremental encoders with C54, C74 (main shaft) and C98 (power clamp)
- F18Error codeTimeout Mod 31, Watchdog: Recorded during start-up: Watchdog causes last reset. Please check error record (C28). Mod 42, Data cond. : Can’t get data from external AD converter This error can caused by - a malfunction of the incremental encoder. Please check C74 and C54. - a malfunction of the micro-controller board Check C75 if ADE1 and ADE2 displays valid results. Mod 44, SAPE : Communication timeout (No answer from AWP) Mod C1, Self-test : Self-test failed, test function does not response (timed out)