Skip to content
RemFixitSearch fault code

Error code

Imperial manifold gauge seti All models code P8-1

For your safety

This fault is rated high and involves an area that affects personal safety. No remote repair or do-it-yourself instructions are given; do not use the appliance or try to open or repair it.

Hazard area: mains voltage and pressure vessel

Do not use the appliance and call an authorised service. If there is a risk to life, move to a safe place and see the emergency numbers.

The emergency numbers here are for Turkey. If you are outside Turkey, call your local emergency number.

All emergency numbers and province details

No approved translation for this record yet; showing the original text.

Meaning

Perishable Mode Pull Down Test / eAutofresh CO 2 Sensor Calibration

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

The set point is changed to 0C (32F), and a 180-minute timer is started. The left display will read “P8-1”, the right display will show the supply air temperature. The test passes if the container temperature reaches set point before the 180-min- ute timer expires. On units where the CO Sensor Status indicates that a CO sensor is present, cali- 2 2 bration of the CO sensor will be attempted during P8-1. Once P8-1 begins, calibra- 2 tion will be attempted when the supply temperature goes below 5C. If the CO 2 sensor voltage reads within the 0.95 <>1.15Vdc range before the end of P8-1, the sensor will be calibrated by holding the CO zero line low for 4 seconds. If the voltage is not within this range, CO sensor calibration fails. 2

Solution

Solution steps are not shared for faults that may be dangerous.

No do-it-yourself solution is given for this fault. For your safety, call an authorised service.