Error code

h/p/cosmos vakumlu koşu bandı All models code OP34

For your safety

This fault is rated critical. No remote repair or do-it-yourself instructions are given; do not use the appliance or try to open or repair it.

If there is a risk to life, first move to a safe place, then call 112. Do not follow remote repair instructions.

Call 112

The emergency numbers here are for Turkey. If you are outside Turkey, call your local emergency number.

All emergency numbers and province details

No approved translation for this record yet; showing the original text.

Meaning

Manual speed calibration (counted increments from the speed sensor for 10 m belt movement) Note. Normally the speed calibration values are set by selecting the correct device type (administrator option number 3)

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

This value is permitted to be changed only if the final drive ratio changes. If you change the speed calibration value, please also pay attention to the correct settings in OP5 (firmware speed limit), OP11 (speed measurement; To change the speed calibration value, please use the + and - buttons. For quick movements between standard values, please use the UP and DOWN buttons. If the speed measurement is switched off in OP11, OP34 will only report internal program absolute values. Otherwise, you can see the stored values in the list of running machines types in the appendix

Solution

Solution steps are not shared for faults that may be dangerous.

No do-it-yourself solution is given for this fault. For your safety, call an authorised service.