Parameter

GE Healthcare mamografi cihazı All models code SW1

For your safety

This fault is rated high and involves an area that affects personal safety. No remote repair or do-it-yourself instructions are given; do not use the appliance or try to open or repair it.

Hazard area: mains voltage

Do not use the appliance and call an authorised service. If there is a risk to life, move to a safe place and see the emergency numbers.

The emergency numbers here are for Turkey. If you are outside Turkey, call your local emergency number.

All emergency numbers and province details

No approved translation for this record yet; showing the original text.

Meaning

1. Enter the Install Options Screen 1. (“How do I access the service setup / install options screens?” on page 5-27.) 2. This opens the Diagnostic Control screen. 3. At the bottom of the Diagnostic Control screen, the field SW1 appears followed by a total of 8 ones and zeros. These represent the state of the dip switch settings on the motherboard. A 1 indicates the switch is open (Off), and the associated signal is enabled. A 0 indicates the switch is closed (On), and the associated signal is disabled. 4. The eight switches are defined as in the following table. 5. On the line immediately below the dip switch settings, the current configuration is interpreted as text information. For instance, when the dip switch settings indicate 11101100, the configuration line will read “MECG MSpO NIBP CORO “to 2 indicate that MECG, MSpO and NIBP are enabled, and that the J102 outputs 2 voltage levels are set to the Corometrics Analog Interface Standard. 6. To exit the Service mode following the

Technical details

LED patterns and parameter values are shown only to technicians authorised for this branch.

View details as a technician

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Solution

Solution steps are not shared for faults that may be dangerous.

No do-it-yourself solution is given for this fault. For your safety, call an authorised service.