Error code

Fuji asansör All models code Hz2

For your safety

This fault is rated critical. No remote repair or do-it-yourself instructions are given; do not use the appliance or try to open or repair it.

Hazard area: brakes

If there is a risk to life, first move to a safe place, then call 112. Do not follow remote repair instructions.

Call 112

The emergency numbers here are for Turkey. If you are outside Turkey, call your local emergency number.

All emergency numbers and province details

No approved translation for this record yet; showing the original text.

Meaning

Coast - to - stop komutu Alarm sıfırlama Trip komutu (Harici hata) Jogging işlemi Frekans ayarı 2 / Frekans ayarı 1 Motor 2 / Motor 1 DC fren komutu Tork sınırlayıcı 2 / Tork sınırlayıcı 1 Hat ve invertör arasındaki anahtarlama işlemi (50Hz) Hat ve invertör arasındaki anahtarlama işlemi (60Hz) yukarı komut AŞAĞI komutu TUŞ TAKIMI için yazma etkinleştirme PID kontrolü iptali Ters mod değiştirme 52 -2 için güvenlik kilidi sinyali TRQ kontrolü iptali Bağlantı etkinleştirme (RS -485, Bus) Evrensel DI Alma başlatma modu SY-PG enabled Synchronization command Zero speed command

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

View details as a member

Possible causes

(BX): ON ........ The inverter output is cut off immediately and the motor will coast-to-stop. (No alarm signal will be output.) (RST): ON...... Faults are reset. • The inverter output is cut off and the motor coasts-to-stop. Alarm signal will be output. • This signal is held internally and is reset by inputting RST signal. • Used to protect overheating of external braking resistor. (JOG): ON .... JOG frequency is effective. (Hz2/Hz1): ON ..... Freq. (M2/M1): ON .......The motor circuit parameter and V/f characteristics are changed to the second motor's ones. (DCBRK): ON ..... The DC inUXction brake is effective. (In the inverter deceleration mode) (TL2/TL1): ON .... Torque limiter 2 is effective. (SW50(SW60)): ON The motor is changed from inverter operation to line operation. (SW50(SW60)): OFF The motor is changed from line operation to inverter operation. (UP): ON ........... The output frequency increases. (DOWN): ON .... The output frequency decreases. · The output frequency change rate is determined by ACC / DEC time. · Restarting frequency can be selected from 0Hz or setting value at the time

Solution

Solution steps are not shared for faults that may be dangerous.

No do-it-yourself solution is given for this fault. For your safety, call an authorised service.