Error code

Frigidaire All models code E59

No approved translation for this record yet; showing the original text.

Meaning

No tacho signal for 3 seconds

Member details

Signed-in members see the LED pattern and how to read the code with the remote control on eligible records.

Possible causes

1. Remove the belt from the motor and spin the motor pulley. Does the motor spin free? No, replace the motor. Yes, go to step (3). 2. Spin the tub pulley. Does the tub spin free? No, check the tub bearings. Yes, go to step (3). 3. Disconnect the plug from the drive motor and measure the resistance between pins 4 and 5 in the motor. If the meter reads other than between 105 and 130 ohms, replace the motor. If the reading is between 105 and 130 ohms, go to step (4). 4. Disconnect the plug from the motor and measure the resistance of the windings (pin 1 to 2, pin 1 to 3, pin 2 to 3). All readings should be between 4 and 6 ohms. If readings are correct, replace the Speed Control Board. If readings are incorrect, replace the motor

Solution

Solution steps are available to members and are not shown on this page. Answer the questions to open the solution.

Remote technician support

Get help from a technician over a video call.

Send a message Voice call Video call