Fischer Panda gemi jeneratörü All models error codes
Codes
- 1Error code1. Disturbances on the electrical system/user side. 2. Motor disturbances
- 2Error codeProcessor voltage
- 4Error codeInput temperature signal T05 RWI-A (raw water inlet)
- 6Error codeInput temperature signal T06 RWO-A (raw water outlet)
- 7Error codeOutput + Y 11 (Actuator motor)
- 8Error codeInput temperature signal T07 FWI-A (fresh water inlet)
- 9Error codeOutput - Y 11 (Actuator motor)
- 10Error codeInput temperature signal T08 FWO-A (fresh water outlet)
- 11Error codeControl output K08-CK (cooling pump)
- 12Error codeInput temperature signal T09 LO-A (lube oil)
- 14Error codeInput temperature signal T01 CH-A (cylinder head)
- 16Error codeInput temperature signal T14 AB-A (bearing)
- 18Error codeInput temperature signal T03 EM-A (exhaust manifold)
- 20Error codeInput from fuel level sensor
- 22Error codeInput temperature signal T10 C1-A (coil)
- 23Error codeBinary input P02 OP-B (oil pressure)
- 24Error codeInput temperature signal T11 C2-A (coil)
- 26Error codeInput temperature signal T12 C3-A (coil)
- 28Error codeInput temperature signal (not in use)
- 30Error codeInput temperature signal (not in use)
- 32Error codeInput temperature signal (not in use)
- 33Error codeInput oil pressure signal P01 PO-A (analog)
- 120V-60Error codeIf the generator is unable supply enough power to start an electric motor (120V-60Hz), it is usually because the motor draws too much current during starting process
- han100VError codeRefer to "motor faults" section
- J3Error codeDynamo excitation resistor 68R is switched on with Fuel-Pump (1)
- J201Error codeT-Engine-input, for contact, which opens in case of error (2)
- J202Error codeWater leak-input / Replace air filter, for contact, which opens in case of error (2)
- J203Error codeOil-Press-input, for contact, which opens in case of error (2)
- J204Error code
- J205Error codeT-Winding-input, for contact, which opens in case of error (2)
- J206Error codeInput Water leak has red LED and switches off
- J207Error code
- J210Error code
- V54Error codeLED V54
- V55Error codeLED V54
- X63Error codeConnection VCS sensors