Ferno All models error codes
Codes
- age20Error codeNOTICE The iN∫X is water-resistant. Cover the battery cable with a plastic bag. ● DO: Keep the nozzle pressure setting at 3000 psi/20,684 kPa or less and 4 gallons per minute/15 liters per minute or less. ● DO: Keep the nozzle at least 18 inches/457 mm from the surface of the iN∫X at all times during cleaning. ● DO NOT: Spray water upward into the cables or forcibly at or around the display
- bly65Error code
- H03Error codeCommunication error
- L01Error codeImproper charge voltage (voltage too high)
- L06Error codeBattery over-temperature
- M01Error codeActuator motor overheated. The actuators are deactivated until the motor cools
- N04Error codeButton pressed longer than maximum time allowed, or both buttons being pressed at the same time
- N06Error codeBattery charging issue
- ure72Error codeWARNING Charging an improper battery can cause injury and damage. Do not charge non-rechargeable batteries. Charge lead-acid batteries only in a well-ventilated area (Only Ferno POWERFlexx® POWERPac batteries are lead-acid type). The appliance (battery charger) is not intended for use by people (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. 73
- X1Error codeCover Battery Cable with Tie Wrap and Bag