Desoutter dijital tork anahtarı All models error codes
Codes
- E01Error codeThe message "Tool fault" is displayed when an unsupported tool is connected at the start-up of the firmware
- E06Error codeStart cycle arrives when the controller is not ready (may be due to a tool change, a Servo drive error, etc. that has not been reset)
- E07Error codeSpindle is disabled after a Reject report. If the Stop on bad report box in the STATION menu is activated, then the tool will be disabled. To enable it, it is necessary to activate the Failure acknowledge input on the I/O port
- E10Error codeReport acknowledgement. The tool does not start when this error is present. If the "Report acknowledgement" parameter of the station menu is activated, the cycle start is inhibited. To release the tool start, send a "rising edge" to the "Request Report" signal on the input port
- to0Error codeThe torque value is constantly equal to 0; there is no error message