Altus Inverter-User-Manual-EN error codes
Codes
- ERR02Error codeOvercurrent during acceleration
- ERR03Error codeOvercurrent during deceleration
- ERR04Error codeOvercurrent at constant speed
- ERR05Error codeOvercurrent during acceleration
- ERR06Error codeOvercurrent during deceleration
- ERR07Error codeOvervoltage at constant speed
- ERR08Error codeControl power fault
- ERR09Error codeUndervoltage
- ERR10Error codeDrive overload
- ERR11Error codeMotor overload
- ERR12Error codePower input phase loss
- ERR13Error codePower output phase loss
- ERR14Error codeIGBT overheat
- ERR15Error codeExternal equipment fault
- ERR16Error codeCommunication fault
- Err17Error codeErr17 is reported at power-on or during running
- ERR18Error codeCurrent detection fault
- ERR19Error codeMotor tuning fault
- ERR21Error codeEEPROM read-write fault
- ERR23Error codeShort circuit to ground
- ERR27Error codeUser-defined fault 1
- ERR28Error codeUser-defined fault 2
- ERR30Error codeOff load fault
- ERR33Error codeCommunicati on receiving timeout inside drive board
- ERR40Error codeQuick current limit
- ERR41Error codeMotor switchover fault during running
- ERR42Error codeOverspeed error
- ERR96Error codeCommunication receiving timeout inside control board
- Fd-04Error codeCommunication timeout
- Fd-05Error codeCommunication protocol selection
- Fd-06Error codeCommunication read current resolution
- P0-02Error codeCommand source selection
- P0-03Error codeMain frequency source X selection
- P3-14Error code0V~motor rated voltage
- P5-01Error codeFMR output function selection
- P5-02Error code2 Fault output
- P5-06Error code
- P9-48Error codeOnes place: Encoder/PG card abnormal 0: Free parking Tens place: abnormal reading and writing of function code 0: Free parking 1: stop according to the stop mode Hundreds place: Inverter overload fault action selection 0: Free stop 1: Derating operation Thousands: Motor overheated Ten thousand: the running time arrives
- P9-49Error codeOnes place: User-defined fault 1 0: Free parking 1: stop according to the stop mode 2: keep running Tens place: User-defined fault 2 0: Free parking 1: stop according to the stop mode 2: keep running Hundreds place: the power-on time arrives 0: Free parking 1: stop according to the stop mode 2: keep running Thousands: drop load 0: Free parking 1: Decelerate to stop 2: Jump directly to 7% of the rated frequency of the motor and continue to run, when the load is not dropped Automatic recovery to set frequency operation Ten thousand: PID feedback lost during running 0: Free parking 1: stop according to the stop mode 2: keep running
- PC-17Error codeSimple PLC retentive selection
- PD-04Error codeCommunication timeout
- t4Error codeThe motor ramps up to the expected frequency
- t5Error codeMotor runs at expected frequency
- t6Error codeThe motor ramps down to zero frequency