Deep Sea Electronics jeneratör kontrol paneli All models error codes
Codes
- 2-14Error codeThe module detected that communications to one of the DSENet® expansion modules had been lost
- 2-27Error codeCharger Fan Locked
- 2-40Error codePriority Selection Error
- 2-46Error codeThe module detected that circuit to the engine oil pressure sensor had become open circuit
- 2-50Error codeThe module detected that the generator output current had risen above the Generator Over Current Trip
- 2-51Error codeThe module detected that the generator earth fault current had risen above the Earth Fault Trip Level for the duration of the IDMT function
- 2-52Error codeThe module detected that the generator output voltage had not risen above the Generator Loading Voltage setting after the Warming Up timer had expired
- 2-71Error codeThe module detected that circuit to the engine fuel level sensor had become open circuit
- 056-010Error codeOver Current Protection
- 056-019Error codeEarth Fault Protection
- 056-076Error codeReading DSEGencom Alarms
- 056-092Error codeRecommended Practices for Wiring Resistive Sensors
- 057-220Error codeOptions for Communications with DSE Controllers
- C37Error code
- DM1Error codeDiagnostic Message 1 A DTC that is currently active on the engine ECU
- EEE37Error codeCharge Alt Failure IEEE 37.2 - 27 DC Undervoltage Relay
- ID0Error codeThe module detected that an analogue input value of a DSE2130 had risen above the Flexible Sensor High Pre-Alarm Trip level
- ID1Error codeThe module detected that an analogue input value of a DSE2130 had risen above the Flexible Sensor High Alarm Trip level
- or51NError codeThe module received an amber fault condition from the engine ECU
- to3Error codeThe module detected that a battery charger connected by DSENet® had issued a Common Warning Alarm
- V1Error codeGenerator L1 (U) Voltage Sensing
- V2Error codeMains L1 (R) Voltage Sensing