CPS dijital manifold All models error codes
Codes
- C3-15Error codeCalibration not completed Reported angle sensor value out outside normal range more than 3 degrees Stuck ON (on @ power up) Generator & Engine RPM do not match by more than 100 RPM for > 2.5 seconds
- C4-4Error codeRelay Contact Stuck · Platform Estop detected when Key Switch is in Ground Position or · Platform Estop not detected when key switch is in platform position Voltage on both or none, or not 24V Too much weight in the platform detected by LS18 No CAN communication No CAN communication Wrong software v
- C25-1Error codeNo CAN communication
- C27-4Error codeEngine Speed higher than setting Engine Speed lower than setting Either the over temperature or low oil pressure switch provided a ground to relay CR64 to shut down the engine. A time delay of 5 seconds gives the oil pressure time to build after the engine is started. Drive motors do not slow during
- C27-5Error codeOpen Circuit or Ohms > 60 Short or Ohms < 5 >4850 mV Calibration Not Completed Reported angle sensor value out outside normal range more than 3 degrees Open Circuit or Ohms > 60 Short or Ohms < 5 Open Circuit or Ohms > 60 Short or Ohms < 5 Not between 2000 & 3000 mV at startup Open Circuit or Ohms >
- C46-11Error codeNot between 2000 & 3000 mV at startup Calibration not completed Calibration not completed
- C47-4Error codeOpen Circuit or Ohms > 60 Short or Ohms < 5 Open Circuit or Ohms > 60 Short or Ohms < 5 Open Circuit or Ohms > 60 Short or Ohms < 5 Open Circuit or Ohms > 60 Short or Ohms < 5 Not between 2000 & 3000 mV at startup Open Circuit or Ohms > 60 Short or Ohms < 5 Open Circuit or Ohms > 60 Short or Ohms <
- C47-6Error codeOpen Circuit or Ohms > 60 Short or Ohms < 5 Not between 2000 & 3000 mV at startup Genie Telematics Device not detected when option is enabled Not between 2000 & 3000 mV at startup Calibration not completed