Bosch anons sistemi All models error codes
Codes
- A01Error codeHeating cable in condensate drain is defective and drain is frozen
- A61Error codeBroken room sensor
- A62Error codeBroken room sensor
- A63Error codeBroken room sensor
- A64Error codeBroken room sensor
- CA0MError codeAĞ KABLOSU KOMPLE 0,5M
- CA005Error codeAĞ KABLOSU KOMPLE 5M
- CA020Error codeAĞ KABLOSU KOMPLE 20M
- den255Error codeBack-up power supervision (Yedek güç denetimi) On (Açık) iken ve yedek güç başarısız olduğunda bir arıza olayı oluşturulur
- H01Error codeThe flow is blocked because of bad electrical connection to circulation pump
- han50Error codeEvery rupture of a fuse or the operation of a protected device that affects a mandatory function will result in a fault since the mandatory functions are supervised. The reported fault is as close to the located defect as possible. E.g. a mains related fault is reported as a mains fault and an amplifier defect is reported as defect for that amplifier channel
- hin10Error codeAfter fault detection of an amplifier all loudspeaker lines are switched automatically to the spare amplifier (if connected and configured) within 10 s
- in8Error codeThe Praesideo system offers two ways of visual indication of individual faults: via the front panel menu of the network controller and via the Praesideo logging application
- kin14Error codeDenetleyici ve uzaktan kontrol panellerinin tümünde arıza durumunda siren olarak kullanılan bir monitör hoparlörü bulunur
- m46Error codeSistemde her arıza saptandığında kontrol çıkışı alarm zilini (ör. bağlı zil) aktif hale getirir. Sadece tüm arızaları kabul ederek devre dışı bırakılabilir
- of1Error codeThe Power/Fault LED of Praesideo call stations is yellow (on or flashing) when the system is in the fault warning condition. Disablement indication is not available in the Praesideo system since Praesideo does not support the optional disablement condition
- or3Error codeA control output contact of a Praesideo system component can be configured as Fault alarm buzzer. This output contact can be connected to a buzzer. This way all faults, including system faults, are indicated audibly. The Fault alarm buzzer can be silenced by acknowledging all faults via a key or control input that is configured as Fault acknowledge key. The control output for the visual Fault alarm indicator is only deactivated upon resolving and resetting all fault conditions
- see13Error codeThe IUI describes the following means to limit the consequences of fault: • Switchover to spare (standby) amplifiers • Audio/control input supervision • Backup power supply • Redundant network cabling • Loudspeaker line supervision • The ability of the emergency call station to make a ‘fail safe’ call in case of a network controller defect • A/B group wiring of loudspeakers • The ability of the multi channel interface to bypass routing in case of a fatal fault in the MCI